I am installing windows 2000 on a IBM eserver with a IBM Serveraid 4xl card
for the storage system. When I start the install I press F6 that will allow
me to specify a specific driver. I insert the floppy when asked and it
detects the proper driver. I select the driver and then let install proceed.
After a bit it give an error that nfrd960.sys was not found and setup fails.
The nfrd960 file is on the floppy so I can not figure out what is happening.

Any ideas would be appreciated, the other option is to install Windows2003
but I can not get the CD drive to read my disk so I was going to attempt an
upgrade to get to 2003, that is the reason for the 2000 install.

Re: IBM Serveraid 4xl Error by Dave

Dave
Thu May 01 19:48:02 PDT 2008

You might try recreating the driver disk. Also make sure the driver version
is compatible with the firmware version.

http://www-304.ibm.com/systems/support/supportsite.wss/docdisplay?lndocid=SERV-RAID&brandind=5000008

http://www-304.ibm.com/systems/support/supportsite.wss/docdisplay?lndocid=MIGR-4QDMES&brandind=5000008



--

Regards,

Dave Patrick ....Please no email replies - reply in newsgroup.
Microsoft Certified Professional
Microsoft MVP [Windows]
http://www.microsoft.com/protect

"Thom" wrote:
>I am installing windows 2000 on a IBM eserver with a IBM Serveraid 4xl card
> for the storage system. When I start the install I press F6 that will
> allow
> me to specify a specific driver. I insert the floppy when asked and it
> detects the proper driver. I select the driver and then let install
> proceed.
> After a bit it give an error that nfrd960.sys was not found and setup
> fails.
> The nfrd960 file is on the floppy so I can not figure out what is
> happening.
>
> Any ideas would be appreciated, the other option is to install Windows2003
> but I can not get the CD drive to read my disk so I was going to attempt
> an
> upgrade to get to 2003, that is the reason for the 2000 install.