Joan
Mon Oct 27 04:27:46 CST 2003
Courtesy of MikeM.
Joan
First boot to DOS using a floppy and check whether you have a WININIT.INI
file in your C:\WINDOWS folder. If present rename it to something like
wininit.old and try booting again. It is also probable that you will have
to
repeat the last software install or update that you made. See MS KB283069 -
"Error Message: (
http://support.microsoft.com?kbid=283069).
If you can't find a wininit.ini file then I suspect your problem is due to
the
C:\_RESTORE\TEMP folder having around 64K files in it which is the limit
(2**16) for the number of files that can be located in a folder using the
FAT32 filing system. This can also lead to the "Cannot upgrade file %1 from
%2.." message when booting. I suggest you try deleting the _RESTORE folder
with the loss of any system restore checkpoints you might have (not that I
think they are now usable) and see if that solves the problem. [BTW do you
have any Symantec applications installed? I ask because LiveUpdate is
implicated in this problem.] Delete the folder as follows:
a) Boot to DOS using a floppy. Do NOT choose "Minimal Boot" from the menu
when booting from a floppy but rather choose "Start computer with (or
without)
CD-ROM support" otherwise the ATTRIB command will not be available.
b) At the DOS A:\> prompt, type:
A:\> ATTRIB -H -S -R C:\_RESTORE
A:\> REN C:\_RESTORE OLDREST
c) Remove the floppy
d) Reboot your PC
Another problem though is that the update you were doing was probably never
completed so your system may still be unusable. If however it does manage
to
boot then
e) Delete the folder C:\OLDREST
f) Check that an automatic system restore checkpoint was created.
g) Finally adjust the space allocated to the restore folder:
System | Performance | File System | Hard Disk and adjust the restore slider
to your preferred setting. A figure of 200MB is normally more than
adequate
for day to day use allowing perhaps a week of checkpoints to be available
although increasing this to perhaps 400MB for a few days during periods of
large installs such Microsoft Office is advisable.
--
Mike Maltby MS-MVP
mcmaltby@hotmail.com
"Jen" <anonymous@discussions.microsoft.com> wrote in message
news:130501c39c46$db4d5cf0$3101280a@phx.gbl...
> whenever I try to update any program which requires a
> reboot. I get and error message during start up which says
>
> Windows could not upgrade the file %1 from %2
> %1: %2
> Windows could not pgrade one or more system files before
> starting.
> Windows may not start or run properly
>
> If Windows fails to start, run SETUP again
>
> Press Any Key to Continue
>
>
> I have no problems with the systems running properly, but
> the program and/or file I am trying to load or upgrade
> doesn't work?
>
> Any ideas?
>