Hi,
I am having two problems with eboot that I can't figure out:
1=2E When eboot tries to load OS from Flash, it sends the following
message to debug serial
Microsoft Windows CE Ethernet Bootloader Common Library Version 1.1
Built Jun 7 2007 14:54:25
Hit ENTER within 3 seconds to change boot setting!
System reaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa.....
serial port keeps seding a's whereas it should have displayed "System
ready!" and "Preparing for download...."
2=2E If I try to burn nk.bin from PB I get the following:
Microsoft Windows CE Ethernet Bootloader Common Library Version 1.1
Built Jun 7 2007 14:54:25
Hit ENTER within 3 seconds to change boot setting!
Ethernet Boot Loader Configuration:
0) MAC Address: 12:13:17:28:31:00
1) Static IP address: 10.10.0.1
2) Static Subnet mask: 255.255.255.0
3) DHCP: Disabled
4) Reset to factory default configuration
5) Save current Eboot Configuration
D) Download image now
E) Erase NOR Flash
L) Launch existing OS Image from NOR Flash
R) Launch existing OS image from RAM
A) AutoBoot: Enabled NOR
Enter your selection: d
System ready!
Preparing for download...
+EbootSendBootmeAndWaitForTftp
Sent BOOTME to 255.255.255.255
Sent BOOTME to 255.255.255.255
Locked Down Link 1
Src IP 10.10.0.1 Port 0400 Dest IP 10.10.0.5 Port 0512
EthDown::TFTPD_OPEN::boot.bin
-EbootSendBootmeAndWaitForTftp
Download BIN file information:
-----------------------------------------------------
[0]: Base Address=3D0x80040000 Length=3D0xF2A67C
rom_offset=3D0x0.
Flash Programming is about to start!
Hit "F" to proceed!
Starting Flash Programming
0xA0040000 0x88240000 0x3CA99F
Sector Erase at [0xA0040000h - 0xA0F6A678h]...
\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/
\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/
\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/
\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/
\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/
\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/
\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/
\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/
Programming at [0xA0040000h - 0xA0F6A678h]...
PPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPP
Flash Write Complete
Flash Verifing at [0xA0040000h - 0xA0F6A678h]...
SSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSS
Flash Programming
Complettttttttttttttttttttttttttttttttttttttttttttttttttttttttttttttttttttt=
tttttttttttttttt....
serial port keeps sending t's. It should have just sent "Flash
Programming Complete".
Is this something wrong the the memory or the program itself? Thanks
for any pointers.