Hi,
I have some problems with the I82365 component under Windows CE 5.0. My
design is based on a embedded X86 Board with VIA Chipset and the RICOH PCMCIA
controller. So the bootloader set the ricoh controller in the I82365
compatible state and I included the following components in a standard X86
image:
PCI Bus, I82365 PCMICA PC Card Host, NE2000 compatible (PCMCIA Card)
When I build the image everything goes ok and I can start the image on the
PC. So Windows CE detects the PCMCIA Card and the card get a IP throw DHCP.
The problem is, that when I take a look under SYSTEM / MEMORY that the Use
of PROGRAM MEMORY increases every few seconds around 4-8 KByte. Windows
doesen´t give the memory back free. So when I do nothing on the PC the memory
will be full after 4-5 hours. Then I get a message that I have to increase
the program memory manually.
I get this feature ONLY, when I include the PCMCIA support. All used
components are standard Windows CE 5.0 components, no Third Party components.
Has anyone an idea, of resolving this problem???
Thank´s in advance for answering my question.
Grettings,
Alex