Hi Sir,
I try to download the bootloader. Using ethernet download image to Lubbock
board's flash with "Enable Image for flash". After image download to flash.
I try to enable the the function "Launch existing flash resident image now"
function. But I can't enable the image properly. The LED show "00 0c 0d e0"
error message. The log informatin as below:
*******Beginning System Initialization*******
SDCLK[1] = MemClk/2
MemClk = 132.71 MHz
Run Mode = MemClk
Turbo Mode = 3 * Run Mode
Mode: RUN
******************************************************
******************************************************
******************************************************
******************************************************
******************************************************
OEMInitDebugSerial using UART1
Microsoft Windows CE Ethernet Bootloader Common Library Version 1.0 Built
Mar 13 2003 23:08:10
Microsoft Windows CE Ethernet Bootloader 3.3 for the Intel DBPXA250
Development Platform (Built Dec 4 2003)
Press [ENTER] to download now or [SPACE] to cancel.
Initiating image download in 5 seconds. 4 seconds. 3 seconds. 2 seconds. 1
seconds.
Ethernet Boot Loader Configuration:
0) IP address: 192.168.80.2
1) Subnet mask: 255.255.0.0
2) Boot delay: 5 seconds
3) DHCP: Enabled
4) Reset to factory default configuration
5) Download new image at startup
6) Program RAM image into FLASH: (Disabled)
7) Program SMSC MAC address
8) Boot device order: SMSC -> PCMCIA -> CF
9) Check image signature(s): (Disabled)
D) Download image now
F) Format flash (will not overwrite eboot or eboot parameters)
L) Launch existing flash resident image now
Enter your selection: 4
Resetting factory default configuration ...
Ethernet Boot Loader Configuration:
0) IP address: 192.168.80.2
1) Subnet mask: 255.255.0.0
2) Boot delay: 5 seconds
3) DHCP: Enabled
4) Reset to factory default configuration
5) Download new image at startup
6) Program RAM image into FLASH: (Disabled)
7) Program SMSC MAC address
8) Boot device order: SMSC -> PCMCIA -> CF
9) Check image signature(s): (Disabled)
D) Download image now
F) Format flash (will not overwrite eboot or eboot parameters)
L) Launch existing flash resident image now
Enter your selection: l
Writing 0x80068118 to flash address 0xB8340000 (length=0xA3C).
Sector=0x200 (Length=0x6) Block=0x1 (Length=0x1).
Handling non-block aligned data...
FlashErase: Unlocking flash block(s) [0x1, 0x1] (please wait): Done.
Erasing flash block(s) [0x1, 0x1] (please wait): .Done.
Writing to flash (please wait): Done.
System ready!
Preparing for download...
Done.
Download successful! Jumping to image at physical 0x81000...
-------------------------------------------
Any suggestion is welcome
Thanks,
JLL