Attach Device problems

Hello... I seem to only be able to "Attach Device" to two particular
MAC addresses.

Does that make any sense at all?

My PB5.0 happily downloads image to the first MAC address I used with
it, and the default that comes with the board... but for the rest of
them (rest = "10 others I tried") don't actually seem to get an image.
I can see the board in "Connectivity options", but when I connect to
get an image, PB sends one packet in response to the BOOTME... and
then nothing happens.

Any suggestions on debugging?

Thanks,

Andy

Valter
Thu Apr 24 06:36:42 PDT 2008

Andrew Schweitzer <anschweitzer@gmail.com> wrote in
news:7764fa1b-8c8d-4563-8fa3-76a642ed0304@59g2000hsb.googlegroups.com
:

> Hello... I seem to only be able to "Attach Device" to two
> particular MAC addresses.
>
> Does that make any sense at all?
>
> My PB5.0 happily downloads image to the first MAC address I used
> with it, and the default that comes with the board... but for the
> rest of them (rest = "10 others I tried") don't actually seem to
> get an image. I can see the board in "Connectivity options", but
> when I connect to get an image, PB sends one packet in response to
> the BOOTME... and then nothing happens.
>
> Any suggestions on debugging?

Try to use a network sniffer (ethereal or someting like that) to check
if the ethernet packets that your board sends contains the configured
MAC or, someway, the default one.

--
Valter Minute
www.fortechembeddedlabs.it
Training, support and development for Windows CE
(the reply address of this message is invalid)