Adding features doesn't work

For a reason there is not any longer possible to add Catlog listed features
from My_BSP to My_New_Platform. (It works fine for the WinCE 5.0 MinestoneII
BSP.)
What might cause this?

I have tried editing the .cec file by the CEC Editor and by textedit, but
are just not able to get this working.

/trond

DOMINO
Wed Nov 30 08:09:01 CST 2005

check the GUIDs in the .cec file

Bolla wrote:

> For a reason there is not any longer possible to add Catlog listed features
> from My_BSP to My_New_Platform. (It works fine for the WinCE 5.0 MinestoneII
> BSP.)
> What might cause this?
>
> I have tried editing the .cec file by the CEC Editor and by textedit, but
> are just not able to get this working.
>
> /trond

Bolla
Thu Dec 01 05:48:32 CST 2005

I have done some changes to my serial port configuration migrating from 4.2
to 5.0.
My BSP is based on the lubbock XSC1BD BSP.
I would like to use the 5.0 Producttion Quality drivers in
CSP\ARM\INTEL\PXA25X, but are not able to do this transition.
Do anyone have the XSC1BD with the lubbock.cec file for 5.0?
/trond

"DOMINO" <Peter.Beard@domino-uk.com> wrote in message
news:1133359741.156993.134570@g49g2000cwa.googlegroups.com...
> check the GUIDs in the .cec file
>
> Bolla wrote:
>
> > For a reason there is not any longer possible to add Catlog listed
features
> > from My_BSP to My_New_Platform. (It works fine for the WinCE 5.0
MinestoneII
> > BSP.)
> > What might cause this?
> >
> > I have tried editing the .cec file by the CEC Editor and by textedit,
but
> > are just not able to get this working.
> >
> > /trond
>

Michael
Thu Dec 01 08:37:55 CST 2005

I had the same problem. Device drivers from the catalog were not showing up
in my project in PB 5.0. It seems that PB tries to determine if a feature is
relevant for your project after you add it from the catalog. Here is what
you can do.

Either (1) define a MODULE_NAME variable in the CEC as the target file name
for that feature, or (2) define a variable in the CEC for that feature that
has the same name as an environment variable that you define in your project
settings or PLATFORM.BAT file.

Then they show up in your project.

--
Michael Schaffner, P.E.
Senior Software Engineer
Windows CE Technical Group
Applied Data Systems


"Bolla" <trond.loekstad@no.abb.com> wrote in message
news:eksUjSb9FHA.2192@TK2MSFTNGP14.phx.gbl...
> For a reason there is not any longer possible to add Catlog listed
> features
> from My_BSP to My_New_Platform. (It works fine for the WinCE 5.0
> MinestoneII
> BSP.)
> What might cause this?
>
> I have tried editing the .cec file by the CEC Editor and by textedit, but
> are just not able to get this working.
>
> /trond
>
>