silvz7105
Mon Mar 31 11:40:39 PDT 2008
Tried that. The NIC2 was set above NIC1 in bindings, changed it such
that NIC1 is at the top.
Still not able to get dedicated communication to the PLC. Im thinking
it might be something in the Designer Program that is limiting me.
Time for a tech support call.
On Mar 31, 12:53=A0pm, "Phillip Windell" <philwind...@hotmail.com>
wrote:
> As long as they are not the same subnet it will probably be fine.
>
> Make sure the second nic does not get placed first in the binding
> order,...Net'Places-->Advanced-->Advanced Settings-->Upper box.
>
> Make sure the second nic does *not* get a Default Gateway. =A0 It should g=
et
> an IP# and mask only.
>
> --
> Phillip Windellwww.wandtv.com
>
> The views expressed, are my own and not those of my employer, or Microsoft=
,
> or anyone else associated with me, including my cats.
> -----------------------------------------------------
>
> <silvz7...@gmail.com> wrote in message
>
> news:794ef392-4784-40a6-811b-a5a62ecf628b@d45g2000hsc.googlegroups.com...
>
> > Hello All,
>
> > I am wondering if thsi setup is possible on a Windows 200 SP4
> > Machine. =A0I would like to use a Dual Network Card setup such that one
> > netwkr card is sued to connected to the domain at my office and the
> > second card can be used to assign a static IP address and connect my
> > PC to a PLC Controller. =A0I can do this using a single card, but it
> > involves me disconnecting from the Work network, and over-writing the
> > TCP/IP settings on the nwetork card.
>
> > I need NIC1 to use a DHCP Assigned IP Address, and NIC2 to use the
> > static 192.168.1.250. =A0NIC2 would only be communicating with a PLC
> > using a PLC Design/Programming application.
>
> > Any ideas would be apprecated.
>
> > -Dave