Sharp VL-Z1 ... Pls help

Hi there,

I was trying to download the video from the camcoder VL-Z1 to my pc through the firewire but failed. I then tried the same thing on another pc and it works, both pc are running Win XP. The only difference I spotted was my pc doesn't really "recognize" the camcoder while the other does as message pop-up as soon as I connect the camcoder to the pc. Did I miss out anything? I'm new to MM2, so pls help. I installed the IEEE1394 correctly for sure, what else should I do? Pls advice.

Graham
Sat Jul 31 04:23:55 CDT 2004

Check in device manager to ensure the firewire card is properly installed.
Did you use the same cable on both pc's? As cheap cables are often a pain,
causing much trouble.
If you did, ensure the cam is on, in vcr/playback mode and powered by the
mains and not battery and then plug and unplug the firewire lead a few times
and see if you can get a connection. If this works get a good quality cable.
If it doesn't. Unistall the firewire card. Turn off pc. Remove firewire
card. Turn on pc. Turn off pc. Refit firewire card, preferably in another
pci slot. Turn on pc and let it reload drivers.
If this doesn't work, repeat but when booting for the final time have the
cam connected and ready.
Graham

--
Graham Hughes
MVP Digital Media
www.dvds2treasure.com
www.simplydv.com

"Chung Kiat" <Chung Kiat@discussions.microsoft.com> wrote in message
news:4A71EC0C-152C-4348-BB94-4EAF217F4884@microsoft.com...
> Hi there,
>
> I was trying to download the video from the camcoder VL-Z1 to my pc
> through the firewire but failed. I then tried the same thing on another pc
> and it works, both pc are running Win XP. The only difference I spotted
> was my pc doesn't really "recognize" the camcoder while the other does as
> message pop-up as soon as I connect the camcoder to the pc. Did I miss out
> anything? I'm new to MM2, so pls help. I installed the IEEE1394 correctly
> for sure, what else should I do? Pls advice.
>
>