Re: Missing during installation by Colin
Colin
Fri Aug 19 16:34:07 CDT 2005
Do the usual, clean the media, clean the drive, try another drive, use brand
new high quality media. Best of luck, I would be very frustrated too.
"waf" <waf@discussions.microsoft.com> wrote in message
news:677BDD07-F23B-4DA4-BACD-126232FCE6CF@microsoft.com...
> This is list of files that refuse to load.
>
> "Setup cannot copy the file: <>
>
> <>=
> wlangwrbk.dll
> wmciwave.drv
> wmfc40u.dll
> wmsxml3.dll
> wnetshell.dll
> wwmdrmnet.dll
> wwmvcore.dll
>
> to rerty press enter
> Escape to skip
> F3 to quit.
>
> second stage of install (after 1st reset)
> it trie to find these files again, but cannot find them on the disk
> although
> they are visible
>
>
>
> "John Barnes" wrote:
>
>> DO NOT update your BIOS to 1013 until after you finish your install per
>> the
>> warning on the ASUS site.
>>
>>
>> "waf" <waf@discussions.microsoft.com> wrote in message
>> news:D0F10205-C4C4-420E-945F-95003EABB223@microsoft.com...
>> > Helo John,
>> >
>> > I meant expand the original ISO. The CD I burnt using NERO boots up as
>> > a
>> > installation fine (See above)
>> >
>> > My current bios 1011 so I will try 1013.
>> > Thanks
>> >
>> > "John Barnes" wrote:
>> >
>> >> When you refer to the expanded ISO, have you expanded the original
>> >> ISO,
>> >> which you probably downloaded to a hard drive, or did you expand the
>> >> CD.
>> >> The problem others have had similar to yours involved bad memory.
>> >> Another possibility is that the latest BIOS requires that the chipset
>> >> drivers be updated BEFORE installing the BIOS. Per the ASUS site:
>> >>
>> >> A8N-SLI Deluxe Bios version 1013
>> >> Please do read the description before updating BIOS
>> >> To avoid crashing file system, please do update the chipset driver to
>> >> below
>> >> version prior to this Bios.
>> >> For WinXP 32bit system, please download and update chipset drivers
>> >> V6.65
>> >> or
>> >> later
>> >> For WinXP 64bit system, please download and update chipset drivers
>> >> V6.65
>> >> or
>> >> later
>> >>
>> >> I don't see any way of performing this during the install, so it may
>> >> be
>> >> necessary to go back to a previous BIOS version.
>> >>
>> >> At least those are a few ideas you can think about until you get some
>> >> expert
>> >> advice.
>> >>
>> >> "waf" <waf@discussions.microsoft.com> wrote in message
>> >> news:FBBFE141-DDB6-4146-800D-2BC653D9803E@microsoft.com...
>> >> > Hi,
>> >> >
>> >> > I am using SATA Hard drives. My dvd drives are your normal ide (I
>> >> > have
>> >> > tried
>> >> > both by the way)
>> >> >
>> >> > I have expanded the ISO onto an independant hard drive and the files
>> >> > requested by the computer seem to be there.
>> >> >
>> >> > During the second stage of installation (ie first restart) I am able
>> >> > to
>> >> > browse the additional SATA drive with the expanded ISO on it. When
>> >> > the
>> >> > installatin program requests for the missing file I have attempted
>> >> > to
>> >> > use
>> >> > the
>> >> > one on the exapnded ISO, but I recieve the same problem.
>> >> >
>> >> > Once setp is compete
>> >> >
>> >> > "John Barnes" wrote:
>> >> >
>> >> >> Your chipset is A8N-SLI Deluxe I would guess. Are you using SATA
>> >> >> or
>> >> >> IDE
>> >> >> drives. Have you tried to read your ISO on another drive or burn
>> >> >> it
>> >> >> on
>> >> >> another drive?
>> >> >>
>> >> >>
>> >> >> "waf" <waf@discussions.microsoft.com> wrote in message
>> >> >> news:2C5E2B22-9C35-41D8-BA72-529A776836F7@microsoft.com...
>> >> >> > System
>> >> >> >
>> >> >> > AMD64 3500
>> >> >> > A8B-SLI Deluxe lateest bios etc.
>> >> >> > winxp 32 on partinion drive c
>> >> >> > winxp 64 drive d
>> >> >> >
>> >> >> > My problem is during the intital installation phase, after I have
>> >> >> > select
>> >> >> > the
>> >> >> > Win64 destination partition, the system begins to copy file but
>> >> >> > will
>> >> >> > randamly
>> >> >> > say it cannont find certain .dll, sys files etc on the CD
>> >> >> > please make sure cd is in drive, retry or skip.
>> >> >> >
>> >> >> > I am attempting to install the trial from the microfot website
>> >> >> > which
>> >> >> > I
>> >> >> > burnt to disk. I have re-download and re-burnt the ISO, but even
>> >> >> > with
>> >> >> > any
>> >> >> > one cd, the files the computer connot find sometimes changes.
>> >> >> >
>> >> >> > I have tried pointing the files on the CD manually, which I can
>> >> >> > see,
>> >> >> > but
>> >> >> > the
>> >> >> > cumptuer fails to pick it up.
>> >> >> >
>> >> >> > If I chose to skip files the install will complete but one
>> >> >> > resatrted
>> >> >> > will
>> >> >> > ask for these files again. The result is automatic update, ie
>> >> >> > update,
>> >> >> > ie64
>> >> >> > do
>> >> >> > not function.
>> >> >> >
>> >> >> > Help.
>> >> >>
>> >> >>
>> >> >>
>> >>
>> >>
>> >>
>> >>
>> >>
>>
>>
>>